LeaforaGet in touch
Garden guides

How do you calibrate a drop spreader for a small Singapore lawn?

Before feeding an estate lawn, ask how many grams of the chosen granular fertiliser the spreader actually delivers per square metre. A dial setting alone cannot answer that question. A measured test run lets the grounds team check the dose before treating the rest of the turf.

What to do

  1. Read the product label and establish the intended rate in grams of product per square metre. If the label quotes kilograms per 100 square metres, multiply that number by ten. For example, 2 kg per 100 square metres converts to 20 g per square metre. This is an arithmetic example. Use the rate appropriate to your product and lawn.
  2. Measure the width of the strip receiving granules and mark a straight test distance. A 0.5 m drop width over 20 m covers 10 square metres. Fit a compatible collection tray if available. Otherwise use a previously untreated strip of the intended lawn, weigh the granules loaded, then weigh what remains after one pass. Use the same tared container for both weights.
  3. Walk at normal working pace and open the gate as you cross the start mark. Close it at the finish. Divide the mass collected or discharged by the test area. If the output is high, narrow the opening and test again. Record the product, setting, operator and measured output for the maintenance handover.

What to avoid

A practical check

Suppose the team loads 800 g and recovers 560 g after the 10-square-metre trial. The machine delivered 240 g, or 24 g per square metre. Against an intended 20 g per square metre that is 20% high. Adjust the gate and check again. At the intended rate a separate untreated lawn measuring 45 square metres would need 900 g.

Read the University of Nebraska turfgrass calibration worksheet for the measured-course and weighing method.

Explore landscape maintenance