How can you check lawn soil depth before the turf arrives?
For a Singapore lawn installation, arrange a check while the prepared soil is still visible. Turf laid over a shallow patch can look much like turf over a deeper one on delivery day. NParks' tropical lawn construction note describes using temporary depth markers to keep the growing layer consistent as the contractor spreads it.
What to do
- Agree what the quote means by soil depth. Ask the installer to identify the base of the growing layer, its specified depth after settling and the intended finished turf level beside the paving. Record those three details before soil delivery.
- Ask the crew to set temporary marked stakes at representative points, including the corners and any change in slope. Photograph the marks against fixed landmarks before the soil goes in. Check the surface against the marks again after the crew has spread and lightly settled the layer.
- Walk the perimeter before accepting the bed for turfing. A level match at one paving edge says little about the depth halfway across the lawn. If a reading falls short, have the installer check both the underlying base and the proposed surface level before deciding how to correct it. Remove temporary markers before laying turf.
What to avoid
- Treating the soil delivery docket as proof of even coverage. A load can be spread thickly at one end and thinly at the other.
- Adding soil to a low reading without checking drainage levels. The correction should preserve the planned fall away from buildings and the working level of drainage inlets.
A practical check
Suppose the agreed settled layer is 150 millimetres. Measurements at three marked positions are 150, 145 and 85 millimetres. Ask the installer to map the shallow area and explain the correction before it disappears under sod. The 150 millimetres in this example is a project specification, not a universal planting depth.
NParks technical note on tropical turfgrass lawn construction, grading and depth markers.
LeaforaGet in touch