LeaforaGet in touch
Garden guides

Why is one lawn corner getting soaked after a sprinkler nozzle change?

If a Singapore estate lawn develops a wet corner after a nozzle replacement, check the new nozzle's flow as well as its spray direction. A corner head watering a quarter circle covers half the area of an edge head watering a half circle at the same radius. Giving both heads the same flow concentrates more water in the corner.

What to do

  1. Watch the affected irrigation zone for one cycle when rain is absent. Sketch the corner and its neighbouring heads. Note the visible spray arcs, where they overlap, whether water runs down a slope, and whether a jet from a damaged head is hitting the same patch.
  2. Ask the installer for the replacement nozzle model and its flow table. Compare the quarter-circle and half-circle entries at the intended pressure and radius. In a matched set the quarter-circle nozzle should deliver about half the half-circle flow. The amount applied per unit area is what needs to match.
  3. After correction, set identical straight-sided cups on level spots across the corner and adjoining turf, run one timed cycle, and compare water depths. If the cups receive similar depths but one patch stays soggy, examine drainage and runoff there before changing the whole zone's timer.

What to avoid

A practical check

For example, suppose the chart lists 4 litres per minute for a half-circle head. A matched quarter-circle nozzle of the same radius would deliver roughly 2 litres per minute at that pressure. Write down the actual model and chart figures at handover so the next replacement can be checked against them.

Rain Bird Landscape Irrigation Design Manual, page 35, on matching application rates across sprinkler arcs.

Explore landscape maintenance