LeaforaGet in touch
Garden guides

Why did a sprinkler keep running during a Hunter rain sensor test?

Check how the watering run was started. On the Hunter controller setup described in its Rain-Clik troubleshooting guide, a manual single-station run overrides the sensor. Pressing the sensor during that run can leave the sprinklers on even when the sensor works. This matters when an estate tests its system after a Singapore downpour.

What to do

  1. Record the controller and sensor models, the station that was watering and whether it started on a schedule or by hand. Check the model instructions before testing. If the controller has a rain-sensor bypass switch, note its position. Hunter specifies Active or On for a sensor test.
  2. On a compatible setup, use Hunter's One Touch Manual Start for the Manual All Stations cycle. While a station is visibly watering, press the accessible Clik sensor test button and watch whether watering stops. Arrange for a second person to watch the sprinkler if it is out of sight of the sensor.
  3. End the test run and return the controller to its usual automatic operation. Write down the start mode, switch position and observed result. If the sensor fails to interrupt the supported test, give those details to the irrigation technician so they can check the sensor and controller connection.

What to avoid

A practical check

Suppose the grounds team starts station 3 by hand and the sprinkler keeps spraying when the test button is pressed. On a second run, started in Manual All Stations with the sensor active, the sprinkler stops. Record both results. If residents saw watering in the rain, the next question is how that particular run started.

Hunter Rain-Clik troubleshooting and supported controller test modes.

Explore landscape maintenance