Will jade vine flowers hang too low over a garden pergola?
Measure down from the beam where the vine will flower. The turquoise blooms of jade vine (Strongylodon macrobotrys) hang in clusters that NParks describes as 1.5 to 3 metres long. An arch with ample headroom when the plant is young can put flowers directly across the path once it blooms.
What to do
- On a side view of the pergola, mark the walking surface and the beam height. Draw a line 1.5 metres down from the beam, then another 3 metres down. These show the published range of cluster lengths. Check where the ends fall relative to the path, seats and planting beds.
- Choose a span above a bed where the clusters can hang freely and visitors can see them from the side. Plan how the woody, twining stems will reach that span. Leave access for a gardener to redirect shoots that reach across to beams above the walkway.
- Check sunlight at canopy level and drainage at the planting point. NParks describes the best conditions as shaded roots and foliage in full sun. An open beam over a well-drained bed can provide both. A solid roof that shades the entire canopy calls for a different position.
What to avoid
- Using the length of a single claw-shaped flower to estimate clearance. The individual flowers are arranged along a much longer hanging stalk.
- Planning to cut off every cluster that reaches the walkway. Place the flowering stems where the full display can remain and the route stays clear.
A practical check
On a drawing with a flowering beam 2.8 metres above the paving, a 1.5-metre cluster would end about 1.3 metres above the path. A 3-metre cluster would reach the paving. Moving the flowering span sideways over a planting bed can preserve the view from the path without sending pedestrians through the flowers.
NParks jade vine profile, flower cluster measurements, light requirements and pergola cultivation.
LeaforaGet in touch