Will one tap and hose reach every bed in a Singapore community garden?
Measure the route the hose can follow from the tap to the farthest planting position. NParks uses 7.5 m as a planning radius based on an average hose length. A bed can fall inside that circle on a drawing yet still be out of reach once the hose has to go around a fence or a raised planter.
What to do
- Mark the tap, gateways, bed corners and shared paths on your sketch. With the gardeners who will use the hose, lay a length of cord along a workable route. Follow the edge of each obstruction. Keep entrances and pedestrian routes available as you test.
- Measure the cord to the nozzle position needed at the far end of each bed. Include the drop from a raised tap and the reach up to elevated planters. Check the return journey too: can someone bring the hose back without dragging it over seedlings or catching it around a post?
- Compare the measured route with the usable length of the actual hose. Try it with the tap on and water the farthest plants at soil level. For a larger site with several awkward routes, mark a candidate second water point and discuss it with the land manager before committing to new beds.
What to avoid
- Sizing the hose from a diagonal line that passes through a planted bed. A gardener who follows that line may pull the hose across the plants every time it changes direction.
- Relying on how far a jet of water travels beyond the nozzle. Check whether a gardener can place water at the farthest plant without spraying a seat, walkway or a neighbouring plot.
A practical check
A tap is 4 m along one side of a fenced bed and the last row is another 5 m around the corner. The diagonal on the plan is about 6.4 m, but the hose route along the two sides is already 9 m before allowing for tap height or slack. A 7.5 m hose falls short. Trial a longer hose along the edge or compare the reach from a second approved tap.
NParks guidance on hose reach, multiple water points and securing a tap for a community garden.
LeaforaGet in touch