LeaforaGet in touch
Garden guides

How do you read a garden rain gauge when the inner tube overflows?

If your manual gauge has a funnel, a graduated inner tube and an outer overflow container, water in the outer container is part of the reading. After a Singapore downpour, measure both portions before the next watering round. A full inner tube alone tells you only how much the first tube held.

What to do

  1. Lift the gauge carefully so water stays in both containers. On a level surface, read the inner tube at eye level at the bottom of the curved water surface. Write down the reading and its unit. Use the marked capacity for your model if the tube is full.
  2. Empty the measured inner tube, keeping all the outer water. Fit the funnel to the empty tube and slowly pour in the overflow, stopping at a readable mark. Record and empty each measured portion. Repeat until the outer container is empty, then add the readings in the same unit.
  3. Record the total with the time the gauge was last emptied and the time you read it. Empty and reassemble the gauge for the next interval. If water spilled or the outer container itself overflowed, mark the catch as incomplete. Use only the amount actually measured as a lower bound.

What to avoid

A practical check

Suppose a gauge marked in millimetres gives 25 mm in the full inner tube. The outer container supplies another 25 mm fill and a final 7 mm. Record 57 mm for the observation interval. If two showers occurred between readings, the log can report their combined catch, but it cannot assign a separate amount to each shower.

The US National Weather Service observer manual illustrates measuring overflow in successive portions. See also pairing a rain reading with a soil check before watering.

Explore landscape maintenance