What should you check on a garden rainwater tank before handover?
For a Singapore household using stored rainwater to water plants, inspect three places with the installer: where water enters, where excess water leaves and where someone opens the tank for inspection. A closed lid can look reassuring while a loose overflow screen still gives mosquitoes access.
What to do
- Trace the inlet and overflow from outside the tank. Ask the installer to show how the corrosion-resistant fine mesh is secured at both openings and how to check it after cleaning. Compare the supplied material and fittings with the dimensions and fastening details in section 2.3 of NEA's domestic rainwater guidance.
- Have the installer demonstrate opening, closing and locking the inspection lid. Look for a continuous rubber seal and check that other access covers fit closely. Keep planting and stored tools clear of the covers so the person maintaining the garden can reach them.
- Estimate actual use before accepting the proposed tank size. Record how many watering cans you use over a week, including rainy days when outdoor pots need little extra water. NEA advises regular turnover and sets a seven-day limit for a batch where water is not continuously used and replenished.
What to avoid
- Counting a partial top-up after a shower as proof the older water has all been used. Ask how the system will be managed through a wet week or when the household is away.
- Leaving a pail below the tap to catch occasional drips. Check the tap and keep spare watering cans emptied, inverted and under cover between uses.
A practical check
Suppose you normally fill a 5-litre can twice a day. That uses 70 litres over seven days. A full 140-litre tank would take 14 days to use at that rate even without another shower. Give the installer those figures and agree on a smaller capacity or a turnover plan suited to your garden.
NEA domestic rainwater collection guidance, section 2.3 on storage tanks and NEA household mosquito prevention checks.
LeaforaGet in touch