LeaforaGet in touch
Garden guides

When can you cut a rooted air layer from its parent plant?

In marcotting, or air layering, a branch grows roots inside a packet of damp moss while it is still attached to the parent. The decision to cut depends on what you can see inside the packet. Fresh leaves at the tip tell you little about the roots.

What to do

  1. Look through the clear wrapping. If you used foil over the plastic, lift the foil briefly. Look for several roots long enough to trace through the moss for a few inches. A single new root tip is a reason to check again later.
  2. If the moss has become pale and feels dry, loosen the upper tie, moisten it and close the packet again. Leave the branch attached while roots develop. Some species take months.
  3. When the roots are well developed, fill a draining pot partway with potting mix. Support the branch, cut just below the lower tie with clean secateurs, and remove the ties and plastic. Set the rooted moss into the pot and gently fill around it.

What to avoid

A practical check

For a shared garden, photograph the packet from the same side at each check. If several lengthening roots can be traced across today's photo, prepare the pot. If only the shoot above the packet has changed, leave the layer attached.

Iowa State University Extension guide to checking and potting an air layer.

Explore garden landscaping