How steep is your lawn bank in percent grade?
If a landscape contractor asks how steep a lawn is, record two measurements: the vertical change in height and the horizontal distance over which it occurs. Divide the height change by the horizontal distance and multiply by 100. Send those measurements with a photograph so the contractor can see which part of the bank the figure describes.
What to do
- On an accessible section, lay one end of a straight board against the ground at the higher point. Aim the other end downhill and raise it until a spirit level shows the board is horizontal. Measure along the board from the upper contact point to the lower end, then measure straight down from that end to the ground.
- Use the same units for both measurements. If the level board spans 200 cm and the ground is 30 cm below its far end, the grade is 30 divided by 200 times 100, or 15%. Label the reading as a percentage. A 15% grade corresponds to about 8.5 degrees.
- Repeat where the bank changes shape, especially near the crest and foot. Mark each position and the downhill direction on the site photo. A single average can hide a short, steeper section that changes how the crew can reach the grass.
What to avoid
- Using a tape laid directly on the grass as the horizontal distance. That tape follows the sloping face and gives a longer distance than the level board.
- Taking a percentage reading as approval to operate a mower. Give the contractor the measurements and let the crew assess the ground, access and limits of its specific equipment. Leave difficult sections for the site assessment.
A practical check
A condo has two grassy banks beside a path. Across the same 2 m horizontal span, one drops 20 cm and the other drops 50 cm. Mark them separately as 10% and 25% on the quote request. Include the path edge and any drain in each photo so the bidder can plan access to each section.
Penn State Extension illustrates percentage grade in lawn establishment. When buying turf, see measuring the planted area on a sloping lawn.
LeaforaGet in touch