LeaforaGet in touch
Garden guides

Why does a sloping lawn need more turf than its area on a plan?

A plan shows the distance across a Singapore garden from above. Turf follows the ground from the foot of a bank to its crest, which is a longer distance. If two installers give different quantities, ask which length each used before comparing the price per square metre.

What to do

  1. On the site sketch, mark the level lawn, the sloping face and any flat landing at the top. For a rectangular bank with an even incline, use the length along the ground from foot to crest multiplied by the width across the bank. Measure each flat landing separately.
  2. Where the gradient changes, split the face into sections at each change of slope. A tape stretched straight between the two ends can bridge a hollow and miss part of the surface. For an inaccessible bank, ask the installer to take the measurements and mark them on the quote.
  3. Ask for the net surface area, allowance for cuts and delivered quantity on separate lines. If the installer measured directly along the slope, that figure already includes the extra surface created by the incline.

What to avoid

A practical check

A uniform rectangular bank is 8 metres wide, with a horizontal run of 4 metres and a vertical rise of 3 metres. Its sloping face measures 5 metres from foot to crest. The plan shows 32 square metres, while the face takes 40 square metres of turf before trimming. Label the 8-square-metre difference as planted surface so it can be checked against the drawing.

Tri-Turf Sod Farms guide to measuring sloping ground. For curves and paved exclusions, see measuring a lawn for a Singapore turf quote.

Explore garden landscaping