LeaforaGet in touch
Garden guides

How wide should netting be for a hoop-covered vegetable bed?

Measure over an installed hoop from one fastening point to the other. A bed's width on plan only gives the distance between its sides. The net has to travel up, around the arch and back down, with enough material left for the way you intend to secure it.

What to do

  1. Install a representative hoop at its working height. Lay a non-stretch cord over the outside, following the route the net will take. Mark the cord at the fastening point on each side, lay it flat and measure between the marks. Check the largest hoop if the frame varies along the bed.
  2. Test the fastening with a scrap of netting. Measure how much material each side needs beyond the marked point for its hem, clip or weight. Add only the allowances your measurement excludes. For an arch measuring 1.85 m between marks and a 15 cm allowance at each side, the required finished width is 2.15 m.
  3. Measure the length separately. For a top panel clipped at the end hoops, measure between those attachments. If the net must close the ends as well, run the cord along the top and down to the intended end anchors. Check that a volunteer can open and refasten one side for weeding and harvest.

What to avoid

A practical check

A school garden wants two covers for the same frame. The shade panel ends at clips on the arches, while the insect net runs down to weights along both sides and closes at each end. Make a cord measurement for each cover and label the two sets of dimensions before requesting a quotation.

The USDA low tunnel overview illustrates coverings, side anchors and access for harvest. For shade selection, see what a shade net percentage means.

Explore garden landscaping