LeaforaGet in touch
Garden guides

Will flexible steel edging bend around a small circular planting bed?

Measure the diameter where the edging will actually run, halve it, and compare that radius with the guide for the exact edging profile. A quote can include enough metres to go around a Singapore courtyard bed while specifying a strip that kinks at its tightest turn.

What to do

  1. Mark the centre and outline on the ground. For a 60 cm circular bed, a string held at the centre with a mark 30 cm from that point traces the proposed edge. Measure across the finished outline in two directions to check it is circular.
  2. Ask for the profile name, height and manufacturer's tight-curve guidance. For example, Straightcurve's 75 mm flexible edging guide describes roughly 35 cm as its tightest smooth curve radius before kinking and shows a ring about 70 cm across. That figure belongs to this profile. Check the sheet for any substitution.
  3. Request a sample ring or a full-size outline before accepting an edging option near its limit. Look from the path side and inspect the joint. A strip that closes into a circle may still show short flat sections, especially on its inside face.

What to avoid

A practical check

Suppose a courtyard detail allows a ring no wider than 60 cm between paving joints. The example 75 mm profile's 70 cm ring would cross the agreed line. Ask for a profile or preformed ring documented for the smaller diameter. If the design can change, mark a wider circle on site and check the path clearance before ordering.

See the circles and tight curves section of the Straightcurve 75 mm edging catalogue. Once the profile fits, see how to measure the total edging length.

Explore garden landscaping