Why do the sprinklers run through the whole garden twice?
If the lawn, hedge and border each water in order and then the same sequence starts again, check what the timer has been asked to do. On a Hunter X-Core, one start time launches every station assigned a run time in that programme. Entering a start for each bed can unintentionally water all the beds several times.
What to do
- Photograph the controller model and record its clock time. For each active programme, copy down the watering days, all enabled start times and the minutes assigned to each station. Match station numbers to actual beds using the handover plan.
- Work through one watering day on paper. Suppose a programme runs the lawn for eight minutes and a hedge for four. With starts at 6 am and 7 am, the lawn gets sixteen minutes and the hedge gets eight. If the intention was one pass through both beds, the second start explains the extra water.
- Ask the gardener whether the second pass is deliberate. On sloping turf, two shorter runs with a soak interval may be intended. Compare total minutes for each bed with the agreed schedule before the authorised operator switches off an unwanted start.
What to avoid
- Keep the run times and the start times distinct. Shortening every station to compensate for an extra programme start can hide the setting that caused the repeat.
- Use the manual for the model installed on your estate. If the controller shows no active station and only a single low head trickles, record that observation separately. A full sequence restarting and one head draining after shutdown call for different checks.
A practical check
After adjusting the schedule, verify the first run and observe the garden at the previous extra start time. Record which beds ran, when they stopped, and who checked. That record lets the next maintenance crew distinguish a deliberate split cycle from an accidental repeat.
Hunter X-Core guidance on repeat cycles. For water escaping from just one head, see how to check a sprinkler that drips after shutoff.
LeaforaGet in touch